This page has moved to https://docs.px4.io/master/en/ros/offboard_control.html.
Click here if you are not redirected.
Offboard control is dangerous. It is the responsibility of the developer to ensure adequate preparation, testing and safety precautions are taken before offboard flights.
The idea behind off-board control is to be able to control the PX4 flight stack using software running outside of the autopilot. This is done through the MAVLink protocol, specifically the SET_POSITION_TARGET_LOCAL_NED and the SET_ATTITUDE_TARGET messages.
Offboard Control Firmware Setup
There are two things you want to setup on the firmware side before starting offboard development.
Map an RC switch to offboard mode activation
To do this, load up the parameters in QGroundControl and look for the RC_MAP_OFFB_SW parameter to which you can assign the RC channel you want to use to activate offboard mode. It can be useful to map things in such a way that when you fall out of offboard mode you go into position control.
Although this step isn't mandatory since you can activate offboard mode using a MAVLink message. We consider this method much safer.
Enable the companion computer interface
Enable MAVLink on the serial port that you connect to the companion computer (see Companion computer setup).
Usually, there are three ways of setting up offboard communication.
- One connected to a UART port of the autopilot
- One connected to a ground station computer
Example radios include:
A small computer mounted onto the vehicle connected to the autopilot through a UART to USB adapter. There are many possibilities here and it will depend on what kind of additional on-board processing you want to do in addition to sending commands to the autopilot.
Small low power examples:
Larger high power examples:
On-board processor and wifi link to ROS (Recommended)
A small computer mounted onto the vehicle connected to the autopilot through a UART to USB adapter while also having a WiFi link to a ground station running ROS. This can be any of the computers from the above section coupled with a WiFi adapter. For example, the Intel NUC D34010WYB has a PCI Express Half-Mini connector which can accommodate an Intel Wifi Link 5000 adapter.